Error -1073807298 when updating the firmware

[savedcoder]

You could also try installing the LeJOS firmware on the NXT. That uses a really different firmware loader. If BricxCC and NXT-G fail, I kinda doubt that this will work either, but it's worth a try.

[ronmcrae]

I recently had one NXT that was stuck clicking in Samba mode. As far as getting firmware onto that brick, nothing I did worked, and I did at least all of what has been discussed above.

Since the brick in question already had a dead screen (which was an older and separate problem) I returned it to LEGO and it was exchanged.

[savedcoder]

I recently had one NXT that was stuck clicking in Samba mode. As far as getting firmware onto that brick, nothing I did worked, and I did at least all of what has been discussed above.

What circumstances did that one fail under?

[superjanneke]

According to the LEGO helpdesk, the error message is bluetooth related, and should not happen during an usb connection.
The problem started occurring during a bluetooth connection, so that kinda makes sense. After a reset the device should be snapped out of this bluetooth mode, so there is definitely something wrong with the brick.
I am now in contact with LEGO to get a replacement brick...

Thanks for all the good advice.

@matallen37: if they let me keep the old brick, I'd be glad to send it to you, if you pay for the expenses...

[mattallen37]

That is really interesting, I have never heard of that before. Well, hopefully you will be able to get a replacement.

And thanks, I would gladly pay shipping (just so long as you don't live too far away).